Home  |   Downloads  |   FAQ  |   Support  |  
Notebook Fry's PC GQ Series Motherboards VGA Cards Quicknote
 
QUICKNOTE 12-SS-QN29XP

FAQ:

• My USB ports stopped working after I installed USB 2.0 drivers from the CD.
• What is the Recovery CD for?
• What are the Hot Key functions?

Q: Why do the USB ports stopped working after I installed USB 2.0 drivers from the CD?

Answer:

Please uninstall the old USB 2.0 drivers under the device manager and install the following:

Updated USB 2.0 Driver

To uninstall, go into the device manager (start button-> right click on 'my computer' -> properties -> hardware -> device manager -> Universal Serial Bus Controller). Remove everything under Universal Serial Bus Controller and install the new USB 2.0 Driver.

Q: What is the Recovery CD for?

Answer:

The Recovery CD contains the original image of the hard drive. Running the CD will over write everything on the hard drive and restore it back to out-of-the-box conditions. This means all the data on your hard drive will be erased. For those who wish to duel boot their QuickNote, you will need to purchase a full retail version of Windows XP.

(Note: the recovery CD should only be used to reformat or recover your system from a major problem. Do not use it if the system is working properly.)

Q: What are the Hot Key functions?

Answer:
Key Combinations Definitions
Power Button
Press this button once to turn On your notebook. Press this button for over 4 seconds to turn Off your notebook. Press the button once to enter the suspend/resume mode under normal operating
Internet Button
Press this button to open the Internet WWW Home short-cut key.
Email Button
Press this button to open the Email reader short-cut key.
[Fn] + F2
Press this function to mute and unmute the system audio function.
[Fn] + F3
Press this function to decrease the volume.
[Fn] + F4
Press this function to increase the volume.
[Fn] + F7
Decreases the brightness level.
[Fn] + F8
Increases the brightness level.
[Fn] + F10
Use this key combination to expand your video screen or reset to its original size
[Fn] + F12
This key combination toggles the display between the LCD display and an external CRT or simultaneous.

©2007 FrysSupport.net. All Rights Reserved.